Stainless Steel Foam On Beer detector FOB
1.stainless steel foam on beer detector FOB is used in long draw draft beer system.
2. It saves 10% beer . It will detect when the keg empties, stop the flow, but keep the line full of beer. This allows you to reattach a keg and keep dispensing without wasting beer if you had to purge the system.
3.It reduces beer foam.Foaming at the end of a keg, and when starting a new keg, costs bar operators through beer wastage at keg change over.
4.It is suitable for screwing on KEG or be mounted on wall.
Setup and Use:
* Attach beverage line from outlet of keg coupler to straight inlet of FOB.
* Attach beverage line from elbow outlet of FOB to faucet shank.
* Connect fresh keg and push down purge button until the chamber fills with beer.
* Push bottom knob in to lift float then pull out for normal operation.
* Attach beverage line from elbow outlet of FOB to faucet shank.
* Connect fresh keg and push down purge button until the chamber fills with beer.
* Push bottom knob in to lift float then pull out for normal operation.
Cleaning Instructions:
1.Disconnect keg and connect line to cleaning system.
2.Push in the round handle (float release) to clean position to prevent float from seating.Clean beer lines.
3.Push down & hold vent knob to allow cleaning solution to fill chamber and exit through vent. This will clean the chamber, vent and drain.
4.Rinse with water. Repeat Step 3 while rinsing with water.
5.Once cleaning is complete and you are ready to reconnect beer, pull out the handle (float release) to work position.
2.Push in the round handle (float release) to clean position to prevent float from seating.Clean beer lines.
3.Push down & hold vent knob to allow cleaning solution to fill chamber and exit through vent. This will clean the chamber, vent and drain.
4.Rinse with water. Repeat Step 3 while rinsing with water.
5.Once cleaning is complete and you are ready to reconnect beer, pull out the handle (float release) to work position.